Oracle Communications Session Border Controller 7 Basic Implementation Essentials Practice Tests and PDFs

The Session Border Controller is not routing calls to a specific SIP endpoint from the backbone realm to the access realm in an Access-Backbone architecture. How can you troubleshoot this routing issue? the access realm the backbone realm E. by checking the local-policy configuration element used for routing from the access realm to the backbone realm

Which three options are valid ways to apply Header Manipulation Rules (HMRs) to your existing configuration? parameter. E. Navigate to the session-group configuration element and configure the in-manipulationid parameter.

You want to configure the maximum duration in seconds of any session in the Session Border Controller. How would you accomplish this? parameter. E. Navigate to the media-manager configuration element and configure the latching parameter.

You were working with the Session Border Controller in configuration mode and you forgot to close your session. Your colleague who connected after you left says that he cannot enter into configuration mode. Why is your colleague not able to configure the Session Border Controller? Telnet/SSH timeouts are set to 0. E. The Session Border Controller supports only five simultaneous Telnet/SSH sessions.

You need to configure the Session Border Controller to perform load balancing between two downstream SIP proxies. Which option shows the configuration elements that you should configure for the load balancing feature? E. local-policy and session-group

What is the drawback of configuring Policy-Based Realm Bridging (PBRB) without the assistance of Header Manipulation Rules (HMRs)? E. The performance is poor relative to other models.

What do you need to do to support ftp service on a media interface? E. Add the IP address of the interface in the hip-ip-list and telnet-address parameters.

Where are passwords and licensing information stored? E. Boot Flash

In which two ways can you remove support for telnet from a media interface? (Choose two.) command. command. command. command. E. Navigate to the phy-interface configuration element and run the remove-telnet-ip command.

You want to view an existing multiple-instance element’s configuration. What step should you perform after you go to the correct branch of the configuration tree? E. Enter the name of the element and then issue the show command.